Then gently use a broom stick to.

Remove the brush bar and broken belt.Make sure to take note of how the belt attaches to the brush roll before removing it (take pictures so you don’t forget!).

Install the new belt by threading it through the brush roll and reinstalling the brush back to its original location..Replace the base plate..Interesting Fact:.

A vacuum’s drive belt can spin 100,000 per minute – or more!Considering these high speeds, it’s not surprising that belts are often broken or stretched.. 3.

Check for a Broken Brush.

It’s possible that the brush roll itself is damaged, which can stop it from turning correctly.Tip away the water..

Repeat steps 3 and 4 until the water runs clear.Then tap off excess water..

Allow the filter to dry for at least 24 hours.Make sure it’s completely dry before refitting.. Dyson recommends cleaning the V10’s filters at least once each month.